Med-fit 1 Betriebsanleitung Seite 7

Med-fit-1-instuctionmanual.qxp_Layout 1 24/07/2020 09:43 Page 4
Chapter 4 : TECHNICAL SPECIFICATIONS
MECHANISM M
01 Channel
02 Pulse Amplitude Adjustable 0-80mA, Max output 80mA peak to peak
03 Output Voltage
04 Wave Form
05 Power supply
06 Size
07 Weight
08 Pulse Rate
09 Pulse Width
10 Burst Mode
(B Mode) (
11 Modulation
12 Operating
Condition C
13 Remark
TECHICAL DESCRIPTION
Dual, isolated between channels
(15.8mA rms) into 500ohm load each channel. (
Adjustable 0-40V, Max output 40V peak to peak
(7.9V rms) into 500ohm load each channel. (
Asymmetrical Bi-Phasic Square Pulse
One 9 Volt Battery, type 6F22
95(H) x 65(W) x 23.5(T) mm
115 grams (battery included)
Adjustable, from 2 Hz to 150 Hz
Adjustable, from 30µs to 260µs
Bursts occur twice per second. The pulse width is
Pulse rate is automatically varied in a cyclic pattern
over a nominal 10 second interval (in max 150Hz). o
Pulse rate decreases linearly, over a period of 4 seconds, P
from the control setting value to a value which is 40% f
less. The lower pulse rate will continue for 1 second and l
then the pulse rate increases linearly over a period of 4 t
seconds to the original value. This will continue for 1 s
second and the cycle is then repeated s
Temperature : 0°~40°C
Relative Humidity : 30%~75%
Atmosphere Pressure : 700Hpa~1060Hpa A
There may be up to a +/- 5% tolerance of pulse width
and pulse rate and +/- 20% tolerance of amplitude a
& voltage. &
4