Koala Kare KB200 Gebrauchsanleitung Seite 2

OPERATING INSTRUCTIONS
Please Note:
To assure proper installation, it is suggested that a qualified person or carpenter install the Koala
Baby Changing Station. Koala Kare Products will not be responsible if the station is not installed
properly.
Koala Baby Changing Stations have been tested to hold a substantial static load. The unit must
be attached to a permanent wall that is capable of holding a substantial load.
Inspection Criteria:
A properly maintained baby changing station:
– Opens and closes smoothly
– Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is
attached to unit at both ends.
– Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
– Provides a clean, convenient place for customers to attend to their children.
Measuring
Tape
Gloves
Drill
Six 1/4"x 3"
Phillips Panhead
Wood Screws
1
TOOLS NEEDED
Phillips Head
Screwdriver
1/8" Drill Bit
(regular and
masonry)
HARDWARE PROVIDED
Four 8-32" x 5/16"
Flange Button-
Phillips Head
Screws
Level
7/32" Drill Bit
(regular and
masonry)
Four 1/4"
Flat
Washers
Stud
Finder
Pencil
1/2" Drill Bit
(regular and
masonry)