Setup & Operating Functions; Inserting And Changing The Batteries - Smart Lab scale Bedienungsanleitung

III. Setup & Operating functions

Inserting and changing the batteries

•
Please open the cover of the battery case at the back of the device.
• Insert 4 AAA batteries (1,5 V). Please pay attention to the polarity.
• The digits "8888" will appear on the LCD Display
• Close the cover of the battery case and wait until the digits "0.0kg" show
on the display.
Note: In case the scale does not operate please remove the batteries and
insert them again.
Your smartLAB
that the batteries need to be changed. In case the batteries are
almost empty, the symbol "
device will power of in 4 seconds You should change the batteries
then.
Please remove the batteries in case you are not going to use
the scale for one month or more in order to avoid an automatic
discharge of the batteries.
The Bathroom Scale as well as the batteries must be disposed
according to the local regulations.
In order to guarantee a correct measurement you should calibrate
the scale always after any location change. Just tip on the scale
and wait until it shows "0.0" on the scale.
® scale Bathroom Scale has a symbol indicating
" will show on the display. The
24