Wheel Data Entry; Wheel Data Entry For Wheel Balancers Without An Ultrasonic Sensor - Mondolfo Ferro MT 3650 Up Betriebsanleitung

- Remove the split pin from the cylindrical protection bush.

Wheel data entry for wheel balancers without an ultrasonic sensor

The machine allows for the diameter and distance values to be entered automatically; the
width value can be entered using the keypad.
- Bring the automatic measuring arm into contact with the inner side of the rim (fig.15).
Take great care to position the arm correctly so as to ensure accurate data reading.
- Keep the arm in contact with the rim until the machine has acquired the wheel's diameter
and distance values. The following screen appears during this phase:
- if only one measurement is taken, the machine interprets the presence of a rim with
balancing using a clip weight on both sides (Dynamic Balancing Programme)
- moving the arm to the rest position, the machine will set up for the manual WIDTH entry.
- in this phase, it is possible to perform an additional acquisition of the rim diameter and
90

WHEEL DATA ENTRY

15
Operator's Manual MT 3650 Up