Notes; Getting Started; Charging The Battery; Switching On The Device - Hama 00062721 Bedienungsanleitung

00062721bda
(D2) (D3) (D4) rechargeable battery:
• Blinks red if the battery charge level is low
• Lights up green if the rechargeable battery is fully
charged
• Lights up green and red if the rechargeable battery
is recharging
(D5) Satellite connection:
• Blinks when the receiver tries to establish a
connection with the satellites
• Blinks jointly with (D1) when the receiver has
established a connection with at least one satellite.
(D6) Operating signal (green):
• Blinks slowly if the receiver is in the standby mode
(Bluetooth is switched off).
• Blinks with alternating speed (D1) when the pairing
mode is active

1.4 Notes:

• In order to ensure good reception in the vehicle,
please place your Bluetooth GPS receiver or,
respectively, the GPS antenna on the vehicle
dashboard
• The enclosed hook and loop tape can be used
to attach the receiver within the vehicle
Under normal circumstances, the hook and loop
tape can be easily removed without a trace. In
exceptional cases, a residue might be left behind
due to sunlight or improper handling. This residue
can be removed with a standard commercial interior
cleaner or cleaning cloth.

2. Getting started

2.1 Charging the battery

• Insert either the car recharge cable or the 230V
power supply in the charging terminal (5) of the
Bluetooth GPS receiver. If the LED D3 lights up green
then remove the charger.
Downloaded from www.Manualslib.com
06.03.2006 16:02 Uhr
manuals search engine
Seite 14
• In order to ensure high battery performance and
service life, please make certain that the
rechargeable battery is completely empty before
each recharge.
• Usually the rechargeable battery has an operating
time of 10 hours (in the Bluetooth mode.)

2.2 Switching on the device

Switch on the device with the main switch (4) as depic-
ted in the diagram above.
Now, start the Bluetooth receiver by pressing at least 3
seconds on the on/off switch.

2.3 Activate device coupling (pairing)

• Press and hold the PAIR button (3) for at least 3
seconds. If the Pairing mode is activated, then the
LED´s D1 and D6 blink with alternating speed.
• The access password for the Bluetooth GPS
receiver is "1234".