Hama BSH-180 Bedienungsanleitung Seite 9

00051681bda.indd Abs2:8 00051681bda.indd Abs2:8
Downloaded from www.Manualslib.com
Receiving a call using the headset
• The headset and mobile phone must be in connection
mode to receive a call using the headset.
• When there is an incoming call, both the headset and
the mobile phone ring. You can accept a call using the
headset by briefl y pressing the multifunction button.
Rejecting a call using the headset
• To reject a call, press the multifunction button for
2 seconds.
Ending a call using the headset
• To end the call, briefl y press the multifunction button
once. The headset automatically switches back to
stand-by mode.
• If the caller hangs up, the headset also switches to
stand-by mode automatically.
Remote control
• You can use the headset as a remote control for
playback functions if it is connected to an audio device
that supports A2DP and AVRCP
• To pause playback, briefl y press the multifunction
button once.
• To continue playback, briefl y press the multifunction
button again.
Scatternet connection
• Scatternet connection refers to the ability of one
Bluetooth device to connect to two devices simultane-
ously. This means for instance connecting the Headset
to Bluetooth phone and USB dongle at the same time.
• The above scenario is only possible if the Bluetooth
phone supports headset and/or handsfree profi les.
Scatternet connection cannot be realized with
Bluetooth phones supporting A2DP because A2DP
enabled phone will make use of both A2DP and
Headset/Handsfree profi les available from headset.
• Via scatternet connection, you can answer incoming
call from a Bluetooth phone while listening to music
from another audio device like PC linked to USB dongle.
• To establish Scatternet Connection, fi rst pair and
connect Headset with Bluetooth phone to save
Headset pairing information in phone.
• Next, disconnect Headset from phone and pair
Headset with the other device, for instance to PC via
USB dongle.
8
manuals search engine
• When paired and connected to PC via A2DP,
establish connection between Headset and Bluetooth
Phone(voice link) by connecting from phone.
Now the Headset is connected to PC via A2DP(stereo)
and phone via SCO(voice).
• On an incoming call while streaming audio from PC,
music will stop followed by bell ring. Click MFB once
to answer the call.
• To end the call, press the multifunction button once. If
the other party ends the call fi rst, then you don't have
to press the multifunction button. When call is ended,
music will play automatically.
04.09.2007 8:41:18 Uhr 04.09.2007 8:41:18 Uhr