ASROCK FM2A88X-ITX+ Handbuch Seite 28

Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.3 No. 6)
Chassis Fan Connector
(4-pin CHA_FAN1)
(see p.3 No. 8)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.3 No. 2)
ATX Power Connector
(24-pin ATXPWR1)
(see p.3 No. 5)
28
Downloaded from www.Manualslib.com
HDLED (Hard Drive Activity LED):
Connect to the hard drive activity LED on the chassis front panel. The
LED is on when the hard drive is reading or writing data.
The front panel design may differ by chassis. A front panel module
mainly consists of power switch, reset switch, power LED, hard drive
activity LED, speaker and etc. When connecting your chassis front
panel module to this header, make sure the wire assignments and the
pin assign-ments are matched correctly.
FAN_SPEED_CONTROL
CPU_FAN_SPEED
Though this motherboard provides 4-Pin CPU fan (Quiet Fan) support, the 3-Pin
CPU fan still can work successfully even without the fan speed control function.
If you plan to connect the 3-Pin CPU fan to the CPU fan connector on this
motherboard, please connect it to Pin 1-3.
ASRock FM2A88X-ITX+ Motherboard
manuals search engine
Please connect the chassis
speaker to this header.
Please connect the fan cable
GND
to the fan connector and
+12V
CHA_FAN_SPEED
match the black wire to the
FAN_SPEED_CONTROL
ground pin. CHA_FAN1 fan
speed can be controlled through
UEFI or A-Tuning.
Please connect the CPU fan
cable to the connector and
+12V
match the black wire to the
GND
ground pin.
1 2 3 4
Pin 1-3 Connected
Please connect an ATX power
24 13
supply to this connector.
12 1
3-Pin Fan Installation