Introduction; Layout (Fig. 1-4); Scope Of Delivery - Zgonc yellow Gardenline NEW GENERATION YGL N.G. 2700 Originalbetriebsanleitung

1. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschine GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113.
We recommend:
Read through the complete text in the operating
instructions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities
in accordance with the recommendations. The
operating instructions contain important information
on how to operate the machine safely, professionally
and economically, how to avoid danger, costly
repairs, reduce downtimes and how to increase
reliability and service life of the machine.
In addition to the safety regulations in the
operating instructions, you have to meet the
applicable regulations that apply for the operation
of the machine in your country. Keep the operating
instructions package with the machine at all times
and store it in a plastic cover to protect it from dirt
and moisture. Read the instruction manual each time
before operating the machine and carefully follow
its information. The machine can only be operated
by persons who were instructed concerning the
operation of the machine and who are informed
about the associated dangers. The minimum age
requirement must be complied with.
In addition to the safety requirements in these
operating instructions and your country's applicable
regulations, you should observe the generally
recognized technical rules concerning the operation
of woodworking machines.
26 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
We cannot accept any liability for damage or
accidents which arise due to a failure to follow these
instructions and the safety instructions.

2. Layout (Fig. 1-4)

1. Rear grip
2. Front grip
3. Front finger guard / Chain break
4. Saw chain
5. SDS system
6. Guide bar cover
7. Guide bar
8. Rear finger guard
9. Power cable
10. Claw stop
11. Safety lock- button
12. Cable hook
13. ON/OFF switch
14. Oil tank cap
15. Oil gauge
16. Chain wheel
17. Guide bolt
18. Operation indicator

3. Scope of delivery

• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
Attention
The device and packaging materials are not toys!
Children must not be allowed to play with plastic bags,
film and small parts! There is a risk of swallowing and
suffocation!
• 1 Electrical chainsaw
• 1 Manual
• 1 chain
• 1 bar
• 1 bar sheath