Troubleshooting - Ibiza sound MK-12A Bedienungsanleitung

MK-12A with B-IN Powered Series

Troubleshooting

One certain method of determining if a speaker is faulty is to substitute a
speaker that is known to work correctly for the suspect ed problem speaker. If the
"known good" speaker exhibits the same symptoms as the suspected problem
speaker, use the information below to isolate the problem.
© Copyright Lotronic 2011
No Output
Possible Cause Action
Speaker cables Check
Substitute "known good" speaker ca bles
Check solder joi ns.
Tighten set-screws on "banana" or Neutrik connectors.
Inspect ca ble for damage
Inspect wi re / connector for stray strand s that may short-and
+ together.
Amplifier
Make sure the amplifi er channel is being fed signal.
Most amps h ave a "signal input" LED to indicate the
presence of a signal. Rep atch the Speaker to an amplifier
channel that is known to be working.
Intermittent
Possible Cause Action
Poor connections While it is possible for a faulty speaker to exhi bit intermittent
ou tput, it's mor e likely that an output cable/connector is the
i nsulation between the tip and sl eeve of jacks. Check th e
soldering on connectors. Tighten the set-screws on "banana"
or Neu trik connectors. Check the insulation between the ti p
an d sleeve of jacks.
Constant noise, buzzing and/or humming
Possible Cause Action
Faulty electronic Any constant noise originates in the amplifier, mi xer, signal
Device processing, source d evices, or line-l evel wiring. Check and
In the signal chain Correct system gro unding as required. Check for noisy
sources or electronic components. Check wiring for faulty
shielding.
Poor low-frequency output
Possible Cause Action
Proper Polarity When two speakers in close proximity to each are connected
O ut-of-polari ty, they can partially cancel each other out
especial ly at low frequencies. Check your speaker cables to
be sur e they are all identically wir ed and connected. Check
ba lanced-line signal ca bles to be sure they are all correctly
wired.
all connectors.