Receiver Settings - auna multimedia UHF200C-HB Bedienungsanleitung

Connecting the headset
Connect the connector of the supplied headset to the connector of
the transmitter (see figure). Set the transmitter to the frequency of the
corresponding microphone.

RECEIVER SETTINGS

1. Turn on the receiver.
2. Channel setting: Press and hold the UP button (5) to enter the channel
setting mode. The screen will blink. Then press the UP (5) or DOWN (4)
button to select the desired channel.
3. Infrared function: Press the DOWN button for a few seconds to activate
the IR function. Then move the IR sensor of the transmitter close to
the receiver and wait for about 3 seconds (the connection will be
successfully established if an RF signal is present).
EN
23