Safety Instructions; Product Description - Rebel Mie-Rb-0015 Benutzerhandbuch

SAFETY INSTRUCTIONS

1. Before using the device, inspect the case for any
mechanical damage. If the case has cracks or is missing
any part, do not use the device.
2. Before measurement, set the proper mode of the device.
3. Do not use the device in temperatures exceeding the
range in specification, in high humidity, and near
explosives and flammables.
4. If the display shows low battery icon, change the batteries.
Otherwise the accuracy of measurements may be
decreased.
5. Turn off the device before opening the battery
compartment cover.
6. Battery must be replaced with a new one and with the
same specification.
7. Do not interfere with the device's internal paths. This may
lead to measurement decrease or damaging the device.
8. Take out the batteries, if the device is not going to be used
for a long time.
9. Clean the device with soft, slightly damp cloth, without
abrasive agents.

PRODUCT DESCRIPTION

1. Sensor
2. Laser beam source
3. Display
4. Measurement button
5. Change the reference point button
6. Units button
7. Turn on/laser button
8. Mode switch
9. Bubble level
EN
3
5
6
8
2 1
4
7
MEAS
ON
8
FT/M SET
9