Cd Operation - auna Scala VCD Handbuch

3. Select your favorite song, tap the PLAY/PAUSE button on your BT device
or the PLAY/PAUSE button on the auna Scala VCD to play or pause the
song from your Bluetooth device.
4. Press the  Button or  Button to select the Next or Previous track.
5. If you want to pair (link) the auna Scala VCD with another Bluetooth
device, press and hold the BT Pair Button on the remote control a few
seconds. The "connected" will flash. The auna Scala VCD will go into
Pairing/Discoverable mode. Repeat steps 3 & 4
Note: For more information, see your Bluetooth device's user manual. If you
are asked to enter a passcode, enter 0000.
Disconnecting a BT device
To disconnect a BT device, do one of the following:
• Press MODE to switch to digital radio or FM radio.
• Switch off Bluetooth on the connected device.

CD OPERATION

Loading and Playing CD Disc
1. Press the MODE button on main unit or remote control to select to CD
mode.
2. Place an audio CD on the center spindle with its label side facing out
towards the CD DOOR,Close the disc compartment.
Play/Pause Control
To pause playback press the CD PLAY/PAUSE button. Press the PLAY/PAUSE
button again to resume playback.
Stop Control
To stop playback press the STOP button.
Skip Track: During playback press the PREVIOUS or NEXT button to
search to the previous or next track.
Direct Select Track: Press the numeric buttons [1], [2], ..., [0] to directly
select the desired track to play. For example when the button [3] is pressed
and then follow by pressing the OK button, it will jump to track 3 to play.
Or when the button [1] and then button [2] are pressed and then follow by
pressing the OK button, it will jump to track 12 to play.
EN
51