What You Need To Know Before Using Laser Acupunkture; Laser Acupunkture - GML BIOLAS 6 Gebrauchsanleitung

the laser will switch off automatically after 20 min.
Please ensure that you switch off the appliance at
the mains switch (1) after treatment, because elec-
tronic appliances use electricity constantly, even in
standby mode, which could result in the batteries
being empty within a few days.
What you need to know before using laser
acupuncture
Because everyone is different, laser acupuncture
will have a different effect depending on the individ-
ual. It is also impossible to give precise information
on the treatment
Give ray treatment to the acupuncture points one
after another by setting the laser tip to the treatment
area and then start the laser as described below.
To find an acupuncture point at another person, you
must keep up with the person's skin contact.
You will find some examples of acupuncture point
areas in the GML Guidebook for Softlaser-Therapy
or in your acupuncture books.
Laser acupuncture
Operating
(See „Product description ",→ p.26.)
1. Switching on
Switch the appliance on using the mains switch (1).
The control lamp (2) will light up green. The
BioLas® 6 now ready for use and the point-
detector is already activated.
2. Find out the skin type
Hold the BioLas® 6 in your hand like a pencil (see
diagram). Touch the contact plate (3) with your
tumb (if you are right handed) or your index finger
(if you are left handed). If you do not touch the con-
tact plate, there will be no display on the point-
detector scale (5).
30