Haws ICM122020 Bedienungsanleitung Seite 45

4. Clean the appliance and its components (See "CLEANING AND MAINTENANCE").
5. Do not fill the water tank with hot water. This may damage the appliance. It is best to fill with water of room
temperature or lower.
Caution! Do not use outdoors. Do not use the appliance in a too cold or too hot environment. When the
environment temperature is lower than 10 ℃ or higher than 43 ℃, the appliance will have problems in making
ice. The optimum ambient temperature is around 25 ℃.
Note: The incline angle of the ice maker cabinet should not exceed 45°during transportation or use. Do not
turn the ice maker upside down. Doing so could cause the compressor or refrigerating system to operate
incorrectly. Please allow time for the fluids in the compressor to settle after the ice maker is moved or
transported. Before using the ice maker for the first time, please wait for 3 hours after the unit has been
positioned in the proper place.
HOW TO USE
1. Ensure that the drain plug at the bottom of the water tank is closed well.
2. Open the lid and remove the ice cube basket and scoop.
3. Pour drinking water into the water tank. Pay attention do not over the MAX line.
4. Replace the ice cube basket and close the lid.
5. Plug in the appliance. The "POWER" indicator light will blink. Now the appliance is ready for use.
6. Press the "SELECT" button to choose the size of ice cube: "S" = Small; "L" = Large. The corresponding light
will be on.
7. Press "ON/OFF" button, the appliance starts to work. The "POWER" indicator light will be constant on.
8. After about 7-15 minutes (depending on the ambient temperature or the water temperature), the first batch
of 9 ice cubes will be produced and dropped into the ice cube basket. You can also check through the
transparent window on the top.
9. The appliance will continue to make the next batch of ice cubes.
10. When you have got your desired amount of ice cubes, stop the ice making cycle by pressing the "ON/OFF"
button and unplug the unit from the wall outlet.
11. Open the top lid and transfer the ice cubes to a freezer.
12. Allow the appliance to reach the room temperature. Empty the water tank after each use.
Note! The produced ice cubes in the basket will melt gradually so please use the scoop to take out the ice cubes
in time. The melted water will be collected into the water tank.
Ice full indication
The "ICE FULL" indicator will light up when the ice cube basket is full and then the appliance will stop the ice-
making cycle automatically. Gently remove the ice cubes from the basket with the scoop. About 5 seconds later,
the appliance will restart its ice making function automatically.
Add water indication
The "ADD WATER" indicator will light up when the water tank is lack of water and the ice-making cycle will stop
automatically. At that time, remove the ice cube basket and add water to the water tank, and then press "ON/OFF"
button to restart the ice-making cycle.
The appliance will start working automatically after about 20 minutes if you forget to restart the appliance after
refill.
How to empty the water tank
Move the appliance forward to a place 60mm away from the working table (A) and open the drain plug (B) to
drain out excess water. You can use a container to catch the excess water. Then, replace the drain plug well in
position. (Fig. 4)
- 44 -