Emerio AC-123282 Bedienungsanleitung Seite 8

6. Cool button:
Press the cool button to turn on the cooling function. The corresponding indicator light will be on. This
function is only effective when the water tank has ice box(es) inside. Do not activate this function when
the water in the water tank is below the "MIN" level; add enough water into the water tank first.
7. Timer button:
Press the timer button to set the shutdown time from 1 to 7 hours. Each time you press this button the
timer value will be added by one hour and the corresponding indicator light will be on.
8. Mode button:
Press the mode button to switch the working mode among normal, sleep and natural. The corresponding
indicator light will be on.
- Normal mode: The appliance works with the same wind speed all the time.
- Sleep mode: The appliance changes wind generally from high to low with short time suspended.
- Natural mode: The appliance changes the wind randomly with short time suspended.
NOTES:
1. It is recommended to change water and clean water tank frequently.
2. Activating the cooling function with insufficient water may cause malfunction of the water pump inside the
water tank.
3. Do not take out the water tank immediately after the appliance is just turned off. Wait several minutes to
avoid the water dripping out from the cooling pad.
CLEANING AND MAINTENANCE
Unplug the appliance during filling and cleaning.
Make sure there is no water on the control panel.
◼ Clean the air filter and cooling pad
1. Loosen and take off the screws on the air filter.
2. Pull the tab (A) to take off the air filter (B) and the cooling pad (C). Pull the air filter outwards on both sides
gently and then remove the cooling pad out.
3. Use a neutral cleaner and a soft brush to clean the air filter and the cooling pad. Rinse with clear water
thoroughly.
4. Put back the cooling pad and air filter in place after cleaning. If you will not use the appliance immediately
after cleaning, please dry them before putting back.
Important: in order to avoid leak, the cooling pad must be installed smoothly.
Water pump
- 7 -