Technical Data; Warranty - Me BELL-401 TX Anleitung

5. Mark the holes with a pencil and put the housing part aside.
6. Drill the holes at the marked points with an appropriate drill bit.
7. Insert one of the dowels supplied into each hole and then screw the rear part of the housing to
the mounting point using the screws provided.
8. Reassemble the radio bell push button and screw the housing together with the two housing
screws.

TECHNICAL DATA

Power supply:
Power consumption:
Frequency and transmission power:
Operating temperature:
Ringing melodies:
Coding:

WARRANTY

This product is warranted to be free from defects in materials and workmanship for a period of 2
years from the date of purchase. This only applies if the product is used in the usual manner and is
regularly maintained. The obligations of this warranty are limited to repair or reinstallation of any
part of the equipment and are only valid on condition that no unauthorised modifications or
attempted repairs have been made. Your statutory rights as a customer are in no way affected by
this warranty.
Please note:
There is no claim under the warranty in the following cases, among others:
• Operating error
• flat batteries or defective accumulators
• wrong coding/channel selection
1x 3 Volt lithium battery type CR 2450
7.0 mA during transmission
0.003mA in idle state
434MHz / <10mW
-15°C - + 45°C
8 ringing melodies
256 digital codes
17
BELL-401 / BELL-402
EN