Technical Features - SW Stahl PROFI Tools 26128L Bedienungsanleitung

2. WARNING: Indicates a potential hazard that requires putting into practice the correct procedures to avoid accidents:
• During the equipment operation, handling and maintenance, always wear personal protective equipment (gloves
against mechanical hazards and safety glasses with side protection);
• Use the hydraulic cylinders only if the coupler was duly inserted in the tube;
• Never exceed the nominal capacity of cylinder pressure, both the charge pressure and the hydraulic circuit pressure
(700 bar);
• Use only pumps with maximum pressure not exceeding 700 bar;
• Install a pressure gauge between the cylinder and the pump to monitor the operating pressure;
• Use rigid blocks (steel or wood) to be placed under or above the cylinder capable of withstanding the maximum
load of the cylinder;
• Do not use the cylinder as a shim or as a wedge;
• Before use, always place the cylinder on a flat surface and make sure that the configuration of stressed components
is stable;
• Distribute the load evenly over the entire surface of the head of the rod (piston) to avoid misalignment or situations
that could cause slippage of the stressed parts;
• Worn or damaged parts should be immediately replaced the with original SW-STAHL spare parts.
3. DANGER: Indicates a situation in which an action or lack of action may cause serious personal injury or even death:
• Keep hands and feet away from the cylinder and the stressed components to prevent personal injury;
• Do not manoeuvre the tubes under pressure, the sudden release of oil could tear the skin, causing serious injury, in which
case you should promptly consult a physician.
• Actuate the exhaust valve of the pump always in a gradual manner such that the components stressed by the
movement of the cylinder do not have counterstrokes and sudden failure.
• Always wear the personal protective devices indicated.

TECHNICAL FEATURES

The mechanical properties, the shape and dimensioning for which they were designed, ensure that SW-STAHL hydraulic cylinders
have a field of use restricted to the automotive industry as:
• Injectors disassembly;
• Bearings assembly;
• Coaxial unlocking of very tight mechanical components;
TECHNICAL FEATURES
TABLE A
Coupling connection thread
Force
Stroke
Dimensions
Max Pressure
Weight
Hole utilized
Temperature range
Recommended fluid viscosity
6
6
20 Ton
3/8" -18 NPT
196.133 N
8 mm.
Ø100 x 60
700 Bar
3,04 Kg.
Ø33
-10°C ÷ 65°C
15÷100 mm²/s
2 6 1 2 8 L
26128L
7