Sleep Function; Delete Memory; Clock Setting - Aiwa RMD-99 ST Bedienungsanleitung

16
en
LISTENING TO STORED STATIONS
METHOD 3: DIRECT KEY IN MEMORY ADDRESS
1. Press the VM button to enter the memory mode.
2. Press the numeric keys 0-9 to enter the memory address directly, and then
press the button ( ) to confirm.
The auto scan function will store all the available stations in the ETM memory.
Notes:
• If the display shows " - - - - " symbol after entering the number, it means that the
entered memory address does not exist.

DELETE MEMORY

Press the VM button, and the "Memory address" will flash in the upper right corner of
the screen. Then use one of the following methods to remove unwanted stations:
METHOD 1: DELETE A SINGLE MEMORY MANUALLY
Turn the TUNING KNOB to select the
memory you want to delete, press and
hold the [DELETE] button until the
word "dEL" and "memory address"
flash; then press the [DELETE] button
to erase the unwanted station from
memory.
METHOD 2: SEMI-AUTO DELETE MEMORY
Press and hold the VM button until
"PRESET " flashes to automatically
search for stored stations, press the
[DELETE] button at any time to directly
delete unwanted memory; The radio will
continue searching until you press any
other button to stop this function.
METHOD 3: MANUALLY DELETE ALL MEMORY WITHIN THE BAND
Press and hold the [DELETE] button
until the word "ALL" flashes in the
upper right corner of the screen, then
press the [DELETE] button to erase all
memory within the selected band.

SLEEP FUNCTION

Press and hold the POWER
1.
button until "SLEEP" and
"ON" or 1~120" show on
the display.
Rotate the TUNING KNOB
2.
to select the sleep timer
from 1 to 120 minutes or
permanently select "ON",
then wait until the radio
turns on automatically to
confirm the setting.

CLOCK SETTING

1. Press and hold the
TIME button until hours
flashing, then rotate the
TUNING KNOB to adjust
the hour.
2. Press the TIME button,
then rotate the TUNING
KNOB to adjust the
minutes while minutes are
flashing.
The auto scan function
will store all the
available stations in the
ETM memory.
Press the TIME button to
3.
confirm the setting.
Notes:
• If the TIME button has not been pressed again within 3 seconds, the unit will
automatically confirm the setting.
• You can also directly key-in the number to set the clock after pressing and hol-
ding the TIME button, this allows the user to set the time by pressing the numeric
keys, then you will hear a prolonged beep sound suggesting that the time has been
set.
For example, to set the clock to 6:35, just enter 0 6 3 5.
17