I N S T R U C T I O N
D I S A S S E M B L I N G
Pull out the worn out wheel
hub/bearing unit with the spindle (1)
and the spindle nut (8).
A S S E M B L I N G
ATTENTION: Be cleaned before
installation of the new wheel
hub/bearing unit, the contact surface
in the wheel bearing housing.
Mount the mounting shells (5) to the
new wheel hub/bearing unit with the
fastening bolts for the mounting
shells (9).
Lay the new hub/bearing unit onto
the mounting plate (2) so that the
pre-assembled bolts (3) touch the
mounting shells (5) through the
wheel stud holes.
Attach the mounting plate (6)
sideways to the drive shaft and lead
the spindle (1) with the attached
mounting plate (2) and new
hub/bearing unit from the front
through the swivel bearing and the
mounting plate (6).
Pull in the new wheel bearing with
the bearing spindle (1) and the
spindle nut (8).
8
301051L_manual_75600_en_de_roh.indd 8
301051L_manual_75600_en_de_roh.indd 8
10.11.20 17:52
10.11.20 17:52