Cleaning Your Rotadent Procare; Storing Your Rotadent Procare; Troubleshooting And Guidelines - Rotadent ProCare Gebrauchsanweisung

Cleaning Your Rotadent ProCare

Cleaning Your Brush Head
To clean the brush head, remove the brush head from the handle and rinse separately under warm
running water.
Cleaning Your Handle
Use a damp cloth to wipe the entire surface of the handle. Make sure the handle is completely dry
before placing the handle back on the charging base.
Cleaning Your Charging Base
Before cleaning your charging base, make sure to unplug the power cord. Place the charging base
on a safe and dry surface. Only use a dry cloth or damp cloth to wipe the surface of the charging
base. Do not plug the charging base into the wall outlet until it is completely dry.
IMPORTANT: Do not clean the charging base by immersing it under water.

Storing Your Rotadent ProCare

If your Rotadent ProCare® will not be used for an extended period of time, unplug the charging
base, clean the appliance as described in the Cleaning Your Rotadent ProCare section, and
store it in a cool, dry place away from direct sunlight.
Troubleshooting Guidelines
PROBLEM
The handle
is not
working...
The handle
is running
slowly...
The brush
head
is noisy...
If you are still experiencing technical issues with your Rotadent ProCare, please contact your local
DenMat distributor for further assistance.
9
a) The battery may need to be charged. Recharge the handle for at least
24 hours.
b) The outlet may not be live. Try a different power outlet. The electricity
supply to outlets in bathrooms may be cut off when the light is
switched off.
c) The handle is on the charging base. Remove it from the charging base
(for safety reasons, the toothbrush will not work in the charging base).
d) Brush head may be damaged. Replace with a new brush head.
a) Battery charge may be low. Put the handle into the charging base
to recharge.
b) It may be time to change your brush head. Replace with a new
brush head.
a) The brush head may not be locked into position. Check the brush head
installation per the instructions in this manual.
b) Excessive toothpaste buildup could be keeping the brush head from
working correctly. Clean the handle and brush head, and then try to lock
the brush head in place again.
c) Replace with a new brush head.
®
SOLUTION
Rotadent ProCare — Instructions for Use
®