Champion CPG2500 Bedienungsanleitung Seite 6

ASSEMBLY
Your generator requires some assembly. This unit ships
from our factory without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the assembly of your
generator, contact yor local dealer. Please have your serial
number and model number available.
Remove the Generator from the Shipping Carton
1. Set the shipping carton on a solid, fl at surface.
2. Remove everything from the carton except the
generator.
3. Carefully cut each corner of the box from top to
bottom. Fold each side fl at on the ground to provide a
surface area to install the wheel kit and support leg.
Install the Wheel Kit (Optional Extra)
CAUTION
The wheel kit is not intended for over-the-road use.
You will need the following tools to install the wheels:
• 17 mm wrench OR adjustable wrench (not included)
• Socket wrench with a 16 mm socket (not included)
• Pliers (not included)
1. Before adding fuel and oil, tip the generator on it's side.
2. Slide the M10x120 fl ange bolt through the washer,
sleeve and wheel.
3. Slide the bolt through the mount point on the frame.
4. Fasten securely with the M10 lock nut.
5. Repeat steps 2-4 to attach the second wheel.
6
Install the Support Leg
1. Attach the vibration mounts to the support leg with
a fl ange bolt M8 x 25 and fl ange lock nuts.
2. Attach the support leg to the generator frame with
fl ange bolts M8 x 16 and fl ange lock nuts and
fasten securely. DO NOT over tighten the lock nuts.
3. Tip the generator slowly so that it rests on the
wheels and support leg.
Connect the Battery (Electric Start Models
only)
1. Remove the protective cover from the red (+) lead on
the battery.
2. Attach the red (+) lead to the red (+) terminal on the
battery with the cap screw (M5x10) and secure with
the lock washer (M5).
3. Repeat steps 1-2 for the black (–) battery lead.