Power Switch - Warm Audio WA-67 Bedienungsanleitung

FEATURES
1. CONTENTS
Your WA-67 package includes the WA-67 microphone,
power supply, IEC power cable, shockmount, 7-pin
Gotham Audio cable and a wood storage box.

2. POWER SWITCH

The power switch is located on the power supply.
3. IEC POWER INLET
The IEC power inlet is located on the rear side of the
power supply and allows for connecting the standard
IEC cable to a wall socket.
4. 115V/230V VOLTAGE SELECTOR SWITCH
A voltage selector switch is located near the IEC inlet
on the power supply and allows the user to set the
appropriate voltage for the country in which they are
operating the microphone. Please be careful with this
switch, as connecting the unit to power with the wrong
5
5
6
voltage setting will likely damage the WA-67 and its
power supply, or even cause injury or death. Typically
the voltage selector switch will be pre-set to the proper
voltage of the country where the product was purchased
and should not be changed.
5. 7-PIN MICROPHONE CABLE
CONNECTOR (FEMALE)
A 7-pin female microphone cable connector is located
on the power supply, and this cable carries both the
voltage going to the microphone and the audio signals
coming back from the capsule. Connect the appropriate
end of the included 7-pin Gotham cable to this
connector, and connect the other end to the connector
on the WA-67 itself.
6. XLR OUTPUT
A standard 3-pin XLR male connector is located on the
power supply. The signal from the WA-67 will exit via
this connector, so it should be connected to a preamp's
input via a standard 3-pin XLR cable.
4
1
2
3