Getting Started - Clearaudio Balance+ Bedienungsanleitung

Getting started:

Please switch off all components of your system and connect your Balance+ phono-preamplifier to
your hifi-system. Please follow now the adjustment steps, as described before.
Just connect the Balance+ with 15-pole Sub-D connector to the corresponding power supply.
Connect the power supply with the mains supply and switch the unit on.
Now you can switch on your amplifiers.
Please note:
Never cover or put anything on top of the Balance+ preamplifier and the power supply , which
could lead into overheating of electronic parts.
Clearaudio recycles your used equipment, free of charge.
Don't dispose the unit through the domestic waste.
Main plug phase polarity:
Ex factory the main supply connector pin, which is conducted to the phase,
is marked with a red spot.
If no phase testing equipment is available, try to find the right position of the main lead by alternately
turning the plug and listening. You will hear the difference!
Please note:
Near use of a mobile phone, can disturb the quality of music reproduction!
Page / Seite 4
Clearaudio electronic GmbH
Spardorfer Str. 150
91054 Erlangen
Germany
Tel/Phon: +49-(0)1805/059595
Fax: +49-(0)9131/51683
www.clearaudio.de
info@clearaudio.de
Balance+
User manual / Bedienungsanleitung
© clearaudio electronic GmbH 2007