Lindy 39392 Benutzerhandbuch Seite 4

User Manual
Specification
▪
HDMI 2.0
▪
HDCP 2.2 & 1.4 compliant
▪
Maximum Bandwidth: 18Gbps
▪
Maximum Resolution: 3840x2160@60Hz 4:4:4 8bit
▪
Supported Audio Formats: LPCM 7.1 CH, Dolby TrueHD, DTS-HD, Dolby Atmos, DTS-X
▪
Maximum Distance & Transmission Medium:
▪
300m (984.24ft) over Duplex LC OM3 Multi-Mode (50/125µm) Fibre Optic Cable
▪
IR Frequency: 30-60kHz
▪
RS-232 Baud Rate: 115200bps / Full duplex
▪
Connections:
▪
Transmitter:
▪
Input: HDMI Type A (Female), USB Type B (Female), DB9 (Female), 3.5mm IR (Female),
DC5V Power (Female)
▪
Output: SFP+ (Female), 3.5mm IR (Female)
▪
Receiver:
▪
Input: SFP+ (Female), 2 x USB Type A (Female), 3.5mm IR (Female), DC5V Power (Female)
▪
Output: HDMI Type A (Female), 3.5mm IR (Female), DB9 (Male)
▪
Power Consumption: 5W per unit
▪
Storage / Operating Temperature: -30°C - 70°C (-22°F - 158°F) / -10°C - 45°C (14°F - 113°F)
▪
Relative Humidity: 0-95% non-condensing
Overview
Front Panel
1. HDMI Type A Port
2. 2 x USB Type A Ports Connect USB Input devices.
3. Dip Switch
4. Power & LINK LED
5. DC5V Power
6. HDMI Type A Port
7. USB Type B Port
8. Dip Switch
9. Power & LINK LED
10. DC5V Power
Connect an HDMI cable to an HDMI display or projector.
Select the up or down position depending on the desired effect, see X
section.
Illuminate when the device is powered, and a successful link has been
established between the transmitter and receiver.
Connect an included 5V 2A power supply.
Connect an HDMI cable to an HDMI source device.
Connect a USB Cable to a source PC.
Select the up or down position depending on the desired effect, see the
installation & operation section.
Illuminate when the device is powered, and a successful link has been
established between the transmitter and receiver.
Connect an included 5V 2A power supply.
English