Display Indications And Symbols; Inserting/Charging The Batteries - VOLTCRAFT LSG-4 Bedienungsanleitung

8. Display indications and symbols

This is a list of all possible symbols and statements on the DMM.
AUTO
Automatic range selection is active
HOLD Data hold function is activated
OL Overload, the measuring range was exceeded
OFF
Off position. The DMM is switched off.
Symbol for battery change
Symbol for the diode test
Symbol for the acoustic continuity tester
OFF Symbol for "button not pressed" (function off)
ON
Symbol for "button pressed" (function on)
AC Alternating size for voltage and current
DC Direct magnitude for voltage and current
mV
Millivolt (exp.-3)
V Volt (unit of electric potential)
Ω Ohm (unit of electric resistance)
kΩ
Kiloohm (exp.3)
MΩ Megaohm (exp.6)
MAX Maximum value display

9. Inserting/charging the batteries

The multimeter requires two AAA batteries for operation. You need to insert new, charged batteries prior to initial
operation or when the battery change symbol appears on the display.
The signal transmitter requires a )V compound battery just like the receiver. You need to change the battery when the
display "L2" is lit or if there is no audible sound on the receiver.
To insert/replace the batteries in the DMM, proceed as follows:
1
• Disconnect the measuring device from all measuring circuits and turn it off.
• Remove the protective rubber frame (12) from the device.
• Undo the screws on the battery compartment cover (11) and remove the cover.
• Place new batteries into the battery compartment observing the correct polarity.
• Now close the housing carefully again.
31