Getting Started; Installing The Stand; Connecting The Cables - Silvercrest LCD 24-9 Wide Bedienungsanleitung

SilverCrest LCD 24-9 Wide

Getting Started

Installing the Stand

1. Place the platform for the stand carefully onto a sufficiently
large and stable surface. The centre of the platform has a hole
that is squared to the front and rounded to the back (see the
following figure). Make sure that the rounded corners are
orientated to the back panel of the monitor.
2. Lift up the screen by holding it on the left and right edges and
place its stand onto the platform. Slightly swivel it sideways and
to the front and back until it clicks into place on the platform.
If you ever have to transport the device, you will have to remove the
stand platform again. For more information, see page 122 –
Removing the Platform for the Stand.

Connecting the Cables

Connecting the Power Cord
1. Connect one end of the AC power cord to the AC inlet (8) on
the back panel (see page 107).
2. Connect the other end to a wall outlet. The wall outlet must be
108
Rear Panel
Front Panel