Adjust The Chute Deflector; Led Headlights; Operation Tips; Maintenance - GreenWorks SNF402 Bedienungshandbuch

EN
2. Turn the grip handle right to move the discharge chute to
the right.
4.5

ADJUST THE CHUTE DEFLECTOR

Figure 9
You can adjust the chute deflector up and down to change the
throwing distance of the snow.
Release the bail switch before you adjust the chute
deflector.
Do not push the trigger so far forward that a gap shows
between the deflector and the chute.
1. Push and hold the trigger on the chute deflector.
2. Move the chute deflector up to increase the snow
distance.
3. Move the chute deflector down to decrease the snow
distance.
4.6

LED HEADLIGHTS

Figure10
Set the headlights on：
1. Push the switch forward.
2. Press the switch.
Set the headlights off：
3. Release the switch.
4.7

OPERATION TIPS

• If it is possible, clear the snow with the direction of the
wind.
• In strong winds, lower the chute deflector to direct the
snow to the ground.
• When you complete the work, let the machine operate for
a while to prevent ice formation in the discharge chute.
• If the snow is deeper than 8", decrease the speed and let
the machine work at its own rhythm.
• Do not use the scraper to remove compact snow and ice.
5

MAINTENANCE

Remove the safety key and battery pack from the machine
before maintenance.
Use only approved replacement parts.
WARNING
WARNING
WARNING
CAUTION
English
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
5.1

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten correctly all the fasteners and caps.
• Clean the remaining snow on the machine with a brush.
5.2

REPLACE THE SCRAPER

Figure 11
Use only approved replacement scrapers.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Pull out the plug.
2. Remove the screw from each side plate.
3. Remove and discard the old scraper.
4. Install the new scraper.
5. Put in the mounting screw and spacers and tighten them.
5.3

REPLACE THE IMPELLER

Figure 12
Use only approved replacement scrapers.
1. Remove the screws and side wear pad of left and right
side covers.
2. Remove the nut.
3. Remove the belt.
4. Remove the the large pulley with a socket wrench.
5. Pull the axle and remove the old impeller.
6. Install the new impeller.
7. Reinstall the components.
5.4

STORE THE MACHINE

• Clean the machine before storage.
6
CAUTION
CAUTION
WARNING
WARNING
WARNING