Intelligent DFES01W Montage- Und Benutzerhandbuch Seite 16

https://www.intelligenthanddryers.com/
1. Drill four Ø 8 mm (Ø 0.31") holes using the supplied template. Clean up the
holes once they have been made. Insert the four plugs until they are flush with
the surface (see figure 6).
2. Pass the 3 electric cables (3 cables 16 AWG 1.31 ) from the wall
through the entrance hole (Ø 22 mm - Ø 0.87") as figure nº 8 shows.
Means for disconnection with disconnection under
overvoltage category III.
During the installation process, the protection
areas should be considered according to
Standard VDE 0100.
3. Assure that the four silent blocks of the base-plate are properly
located. Screw in the four supplied screws to firmly secure the
base of the appliance to the wall (see figure 6).
4. Connect the Neutral and Line (N, L) wires to the terminal block
and the A/V cable to the earth connection screw (Class I) as figure
nº 5 shows.
5. Installing the cover on the hand dryer taking care to insert the
upper tab in its housing in the base-plate (see figure nº 9).
6. Unscrew the screws in a counter-clockwise direction (CCW)
using the supplied special tool (see figure 10).
7. Place the hands inside the detection area of the appliance in
order to assure the right performance of the hand dryer.
Fig. 6