Intelligent DFES01W Montage- Und Benutzerhandbuch Seite 15

2. Remove the cover by rasing it a slight angle until the upper securing tab is
freed (see figure nº 2). Remove the cover in a vertical direction without striking
the inside of the machine (see figure nº3).
WARNING: When the cover is removed, live parts of the
appliance are exposed.
During this operation do not:
- Damage any internal components, especially the electronic circuit housed
under the volute (see figure nº 4).
- Scratch the cove nor the IR sensor protection.
Fig. 1
Fig. 2
Fig. 3 Fig. 4
The appliance's electrical installation is made via rear channelling (figure nº 5),
as follows:
Fig. 5