Maintenance, Care And Storage; Ordering Replacement Parts; Technical Data - EINHELL NEW GENERATION NVK 1601 Bedienungsanleitung

Anleitung NVK 1601_SPK1:Anleitung NVK 1400 D
GB

9. Maintenance, care and storage

Maintenance and cleaning work on the scarifier as
well as removal of the safety devices may only be
performed when the motor is switched off and the
power cable has been pulled.
Worn out or damaged spike drums should only be
replaced by an authorized professional (see address
on warranty certificate).
Do not clean the scarifier with running water,
particularly with high-pressure water.
Ensure that all mounting components (i.e. bolts, nuts
etc.) are always tightened so that the scarifier can be
safely operated at all times.
Store your scarifier in a dry room. In order to ensure
that you enjoy your scarifier for many years to come,
all screwed parts, as well as the wheels and axles,
should be cleaned and lubricated.
Keeping your scarifier in good condition not only
ensures a long lifespan and
high-performance, but also enables the machine to
thoroughly scarify your lawn with minimal effort. For
best results, clean the scarifier with a brush or rag.
Do not use any solvents to remove dirt.
At the end of the season, perform a general
inspection of the scarifier and remove any residues
which may have accumulated.
At the start of each season, ensure that you check
the condition of the scarifier.
If repairs are necessary, please contact one of our
customer service centers (see address on warranty
certificate).
10. Replacing the spike drum
For safety reasons, we recommend having the spike
drum replaced by an authorized professional (see
address on warranty certificate).
Important!
Wear work gloves!
Only replace the unit with a genuine Einhell spike
drum , as this will ensure top performance and safety
under all conditions.
18
24.09.2007 13:23 Uhr

11. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

12. Technical data

Voltage:
Power consumption:
Working width:
Number of blades
Scarifying depth: Infinitely adjustable up to 10 mm
L sound pressure level:
pA
L sound power level:
WA
Vibration on the shaft a
hv
Sound and vibration were measured in accordance
with DIN EN 13684.
Seite 18
230 V ~ 50 Hz
1600 W
39 cm
16 pieces
85 dB(A)
98 dB(A)
≤ 2.5 m/s 2