Customer Service - Waterman IDEAL 20 L Montage- Und Bedienungsanleitung

WARNING: To avoid scalding, make sure that
the shower handle is always in the COLD (blue)
WINTERIZATION
1. Close the water connection to the shower and
remove the garden hose.
2. Open the mixing valve and set it to the hot
position so that the tank and hoses are
completely drained. This takes about five
minutes. Do not use the mixing valve while the
IMPORTANT
• Never use salt or other antifreeze agents.
• The maximum water pressure is 3.5 bar.
Under no circumstances should the shower be
operated via an additional pump or a domestic
waterworks.
• Heating the water tank results in an expansion
of the content. This allows water to leak out of

CUSTOMER SERVICE

Thank you for purchasing one of our products.
Our products are subject to stringent final quality
checks. It can nevertheless not be excluded that
malfunctions or defects may occur. If, contrary to
expectations, the purchased product should not
function properly or should otherwise not be in
PLEASE DO NOT RETURN
TO THE SHOP!
Questions? Problems? Missing parts?
Please contact our customer service if you
need any help.
position before using the shower, and then set the
desired temperature.
tank is being emptied, otherwise the water flow
will be interrupted.
3. Clean and dry the parts of the shower.
4. Store away in a shady and dry place.
The shower must be kept in a frost-protected
place.
the shower head.
• When using the shower for the first time, allow
it to run for a few minutes to remove any plastic
smell.
• Always open the mixing valve from the cold
position to avoid scalding.
good order, please contact our customer service
directly.
As a matter of course, our customer service is
available also after the warranty period.
Waterman Kundendienst
Bahnhofstr. 68, 73240 Wendlingen/Germany
Tel.: +49 (0) 7024/4048666
Fax: +49 (0) 7024/4048667
E-mail: service@waterman-pool.com
5