Sanyo VA-50LAN Installationsanleitung Seite 2

1. Installing the Option Board
Remove the dome cover and then the lens assembly. Place the dome cover back once you have finished the settings.
• Please refer to the Installation Manual supplied with the camera.
CN407
COM/NET
Lens assembly
Spacer
2
3
LAN port
Screw
Note: Confirm that the COM switch on the lens assembly is turned to "N".
2
Drop-prevention cord
4
1
Fixer (blue)
2
Spacer
5
LAN cable
1
Connect the option board pin connector to the
COM/NET terminal located at the reverse side of
the lens assembly.
2
Fit the spacers on the option board into the lens
assembly (2 places).
3
Fix the option board from the reverse side using
the screws supplied with the option board
(3 places).
4
Remove the drop-prevention cord and secure it
together with the supplied fixer (blue) using a
screw.
5
Draw the LAN cable through the hole at the
bottom of the camera unit.
6
Set the lens assembly back to the camera unit.