Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A A . . 7 7 E E l l e e c c t t r r i i c c a a l l c c o o n n n n e e c c t t i i o o n n
Before connecting, make sure the mains voltage and frequency match
those indicated on the appliance data plate.
• Work on the electrical systems must only be carried out by specialised
personnel.
• Connection to the power supply must be carried out in compliance with
the regulations and provisions in force in the country of use.
• If the power cable is damaged, it must be replaced by the Customer
Care Service or in any case by specialised personnel, in order to
prevent any risk.
• Verify that a safety circuit breaker is installed between the power cable
of the appliance and the mains electric line. The contact opening max.
distance and leakage current must comply with the local safety
regulations.
• Be sure to power the equipment with systems that are protected
against overvoltage; the manufacturer declines all responsibility for
effects due to anomalies induced by the electrical supply system.
A A . . 8 8 M M a a c c h h i i n n e e s s p p a a c c e e l l i i m m i i t t s s
• A suitable space must be left around the appliance (for operations,
maintenance, etc.).
• The passages enabling personnel to operate on the appliance must be
at least 100 mm [3.9 in] wide.
• This space must be increased in case of use and/or transfer of other
equipment and/or means or if exit routes are necessary inside the
workplace.
A A . . 9 9 P P o o s s i i t t i i o o n n i i n n g g
• Install the appliance, taking all the safety precautions required for this
type of operation, also respecting the relevant fire-prevention
measures.
• Handle the appliance with care in order to avoid damage or danger to
people. Use a pallet for handling and positioning.
• The installation diagram gives the appliance overall dimensions and
the position of connections (gas, electricity, water). Check that they are
available and ready for making all the necessary connections.
• Prevent the areas where the machine is installed to be polluted with
corrosive substances (chlorine, etc.). In case such prevention cannot
be guaranteed, the entire stainless steel surface has to be coated by a
paraffin protective film spread by using a rag soaked with paraffin. The
manufacturer declines any liability for corrosive effects due to external
causes.
10
Werbung
