Safety Instructions; Proper Use - Heitronic 35833 Installations- Und Bedienungsanweisung

GB Installation and Operating Instructions
Spotlight
Art. No. 35833
These operating instructions are only intended for the products listed above.
They contain important information for the start-up and handling of the product.
Therefore pay attention to these operating instructions, even if you pass this product on to third
parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of technology.
The product fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions


The guarantee becomes invalid if damage occurs due to the failure of following these operating
instructions!

We do not accept liability for any consequential damage!

Commissioning is strictly prohibited if there are any damages to the article.

Do not allow the product to come into contact with extreme heat or naked flames.

The product in its entirety must not be altered or modified. Alterations to the product invalidate the
guarantee.

The type plate must not be removed.

3. Proper Use

The article is designed for use in indoor/outdoor areas.
This product is only intended for lighting purposes and may:

only be operated with a voltage of 230 V ~50 Hz

only be connected according to protection class I (one)

only be operated on normal or non-flammable surfaces.

not be subjected to strong mechanical loads or heavy soiling.
4. Before Installation/Commissioning

The product must only be used outside its packaging.

Take the product carefully out of the packaging.

Make sure that the product has not been damaged during transport before taking it into operation. The
light may not be operated if there are any damages to electrical parts. Repairs may only be carried out by
a qualified electrician.

Keep packaging materials away from children and pets. Asphyxiation hazard!
1 of 2 | Dated 19.10.2016