Technical Data; Troubleshooting - DeLonghi KG520 Bedienungsanleitung

Please note:
Regularly clean the grinders, proceeding as follows:
1. Turn counterclockwise the regulator, to "OPEN" position
(fig. 12);
2. Extract by lifting the upper grinder (fig. 13);
3. Clean the extracted grinder with a stiff bristle brush (fig.
14);
4. Clean the inner grinder with a brush and vacuum up the
residues of coffee with a vacuum cleaner (fig. 15);
5. Re-insert the upper grinder and turn the regulator by
choosing the desired grinding level.
By the time the grinders are subject to wear and the quantity
of ground coffee is reduced. In this case, contact an authorized
service center to buy the new grinders and replace them.

13. TROUBLESHOOTING

The appliance does not work.
The appliance stops during operation.
Poor ground coffee quantity

11. TECHNICAL DATA

Voltage: ..................................220-240V ˜50/60 Hz max. 10A
Abosrbed power: .......................................................... 150W
Weight: .........................................................................3,5 Kg
This appliance complies with European regulation no.
1935/2004 on food contact materials.
12. DISPOSAL
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste sepa-
ration and recycling centre.
Make sure the plug is properly inserted in the socket and that the
socket is working properly.
Nor the ground coffee container (A12) nor the filter holder's ac-
cessory (A7) are inserted. Insert the accessory.
The accessory is not correctly inserted. Extract it and repeat
inserting.
The coffee beans container (A1) is not inserted. Insert the coffee
bean container.
The coffee beans container (A1) is not correctly inserted. Extract
it and repeat inserting.
The appliance is overheating.
The motor thermal fuse has intervened.
Contact the authorised Customer Services.
By the time the grinders are subject to wear and the quantity
of ground coffee is reduced. In this case, contact an authorized
service center to buy the new grinders and replace them ( see
section "10. Cleaning")
13