Installation
❿¤Step3: Connect hose to washer
NOTE
• After completing connection, if water leaks from the hose, repeat the same steps.
Use the most conventional type of faucet for water supply. In case the faucet is square or
too big, remove the spacing ring before inserting the faucet into the adaptor.
Horizontal tap
• Make sure that there are no kinks in the
❿¤When your washer has two valves.
• The Inlet hose which has red connector is
• If the washer has two valves, the energy is
Please use the horizontal tap
Extension tap
hose and that they are not crushed.
for the hot water tap.
saved by using hot valve.
Square tap
13