Remote Control; Changing The Battery Of The Remote Control; Notes For Use; Connected Load - Clatronic HL 3763 Bedienungsanleitung, Garantie

Remote Control

NOTE:
The button cell in the battery compartment of the remote
control has been secured with a foil for transport. This
will extend the durability of the battery. Before initial use
please remove this foil so that the remote control is ready
for operation.
The range of the remote control is limited.
When using the remote control, please ensure that there
are no obstacles placed between it and the sensor on the
appliance.

Changing the Battery of the Remote Control

If the range of the remote control is reduced during use,
please proceed as follows:
1. Open the battery compartment on the bottom of the
remote control by holding the lever inwards and pulling
out the battery compartment.
2. Replace the button cell with a battery of the same type
(CR2025). Ensure correct polarity.
3. Then close the battery lid.

Notes for Use

Connected Load

The appliance supports a power input of 2000 W.
CAUTION: Overload
• When using an extension cord, it must have a cable
cross-section of at least 1.5 mm².
• Do not use multi-outlet power strips, since this appli-
ance is too powerful.
• Do not connect any other powerful appliances to the
same electric circuit.

Safety Switch

Your fan heater features a safety switch that disconnects
the power supply in case the appliance falls over. The safety
switch prevents hazards caused by overheating.
CAUTION:
Place the appliance on a smooth, horizontal surface. Avoid
carpets in order to prevent failure of the safety switch.
NOTE:
As soon as the safety switch has been activated, the
appliance must be set and switched on again.

Electric Connection

1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Connect the mains plug to a properly installed isolated
ground socket. All indicator lamps light up briefly.
HL3763_IM_new2

Operating Buttons

The buttons on the appliance are sensor touch buttons. In
order to perform the corresponding function gently touch the
buttons. Whenever a button is pressed, it will be confirmed
by a beep sound.
Control Remote
Panel Control

Switching the appliance on / off

MODE

Operation

NOTE:
• The operation is explained using the buttons on the
appliance.
• The buttons can only be pressed once the appliance
has been switched on by using the
Switching the Appliance On / Off
• Press the button to switch on the appliance. The ap-
pliance initiates the fan setting and displays the current
ambient temperature. The
avoid overheating, the fan is operating continuously.
• Press the button again to switch off the appliance.
NOTE:
A 30 second timer will start in the display. During this
period the fan remains in operation to cool down the
appliance. The indicator lamp lights. When the timer
period has lapsed, the appliance will automatically
switch into standby mode.
CAUTION:
When not using the appliance, disconnect the mains
plug.

Power Level Selection

Press the MODE button repeatedly to choose between the
available power levels.
Fan operation (without heating)
Power level 1 (1300 Watt)
Power level 2 (2000 Watt)
Use the and buttons to select a temperature between
and °C.
Function
Switch display on / off
Time-delayed switch-off:
to hours
Switch oscillation on / off
Power level selection
( , and )
Increase temperature
Decrease temperature
button.
indicator lamp lights. To
43
30.07.20