Marmitek Easy Icon 10 RF Gebrauchsanleitung Seite 10

You can continue learning more individual keys by following the instructions on the
screen, and then press Done when you're finished.
POWERMID XL AND XS
The Marmitek Powermid XL allows you to extend the distance you can use your remote!
You will be able to hide your IR sender from sight, and still operate your TV or other elec-
tronic devices through entertainment centers, cabinet doors, from another room, etc.
The IR-transmitter will receive the RF commands and sends them using IR through the
transmitter cable included with your package!
SETTING UP MARMITEK X-10 DEVICES
The EasyIcon10RF Remote - coupled with other Marmitek X-10 Home Automation
Modules - gives you the ability to operate everything electrical in your home. Once
you set up your remote, you can operate almost any electrical device from the
remote, using the keys that have been configured for Marmitek X-10 Home
Automation Modules.
Description
Marmitek X-10 Home Automation systems use three types of signals - Infrared (IR),
Radio Frequency (RF), and Power Line Carrier (PLC). The EasyIcon10RF remote can send
either IR, RF signals, or both, depending on how you've set up the remote to operate
different equipment.
SET UP THE REMOTE FOR RF TRANSMISSION
The following example describes how to set up your TV for RF control.
Note: Keep in mind that when you set up a device to be controlled by RF signals, e.g.,
to turn on a TV, then the TV must be connected to an Marmitek RF device, for example
the Powermid XL and XS, which will act on the RF signals to turn the TV on or off.
However, the EasyIcon10RF remote sends RF automatically when you are in Marmitek
X-10 mode.
• Press Home.
• Select Setup using the Side Key.
• At the following screen select More using the Side Key.
• At the following screen select Wireless (RF).
• The Mode screen appears; select the Device you want to set for RF
by pressing its Side Key. (In this example, it's TV. The RF symbol
appears on the TV icon.)
• Press OK to Save.
Note: After following the above steps, when you make selections in TV mode, you will
notice that the transmit signals at the bottom of the screen are now Green. This indi-
10 © MARMITEK