Setting The Parameters - aterno Opti-Plus 5D Handbuch

3 - Setting the parameters

–
From the Shutdown mode
—
Press the
The unit displays the first parameter.
Press the
and validate by pressing
Backlight
1 = Backlight activated (Default display)
0 = Backlight deactivated
Use of the backlight reduces the lifetime of the batteries
Correction of the displayed temperature
If you observe a discrepancy between the
room temperature (thermometer) and the
temperature measured and displayed by the
unit, this parameter allows you to correct this
discrepancy. Correction possible from – 3°C
to + 3°C in increments of 0.1°C.
Presence detection
The activation of this parameter requires a
presence detector on the installation
1 = Presence detector activated
0 = Presence detector deactivated (default)
button for 3 seconds.
or buttons to set the value
.
26