aterno Opti-Plus 5D Handbuch Seite 24

— On the thermostat:
press the
˜ Press the
3 seconds.
The device displays Cnf and the bar graph
scrolls at the bottom of the screen.
The heater recognised is indicated on the
screen of the thermostat.
Press the OK button to store this heater in
the memory.
If the display of the consumption is
enabled, specify the power (in Watts) of the
heating elements.
Confirm with OK.
Press
The heater follows the commands of the thermostat.
The red "
On = Closed
2.4 - Checking wireless
transmission
–
Press the
—
Press the
The unit displays the software version
and the protocol it uses.
button. The unit shows 3 dashes.
button for approximately
to exit the configuration mode.
" LED signals the status of the contact.
Off = Open
button.
button for 3 seconds.
Software version display
Protocol version display
24