PROBLEM CASE: Reset of the receiver (factory settings)
If problems occur during the installation of the motor and the remote controls you may
reset the receiver and repeat the connecting procedure:
HOW TO RESET THE RECEIVER:
Press 4 x the connecting button A of the motor until the white LED light goes
•
on, afterwards please press a 5
The white LED flashes 2 x and will go out. The receiver went back to the
•
original factory settings.
The connecting procedure between remote and receiver can now be executed
•
as described above.
LED
1.
2.
knop/boutton/button/Taste
time.
th
A.
LED +