Werbung
EN
Installation of Motor with built-in receiver + Remote Rontrol Topline - Beds with
RSM functionality (position monitoring)
Please connect the remote controls correctly for a proper use of the motor with built-in
receiver.
Note: in case of a double bed; PLEASE install both bed parts one by one, not
together!!
Connecting or linking of the remote control to the motor can be done in 2 different
ways:
Automatic connecting mode:
•
o
o
o
o
o
o
o
o
Manual connecting mode:
•
o
o
o
o
o
o
o
o
Plug the 220V power plug of the motor to the mains.
After connection to the main power, the white LED lights of the motor
will light up and the receiver enters in an automatic connecting mode.
(FOR THIS REASON -in case of a double bed- PLEASE install
the bed parts one by one to avoid connection problems !!)
You now have 60 seconds to connect the remote control.
Press the remote buttons 1 & 2 (first row) TOGETHER.
On the motor, the white LED flashes 2 x and goes out (the blue LED
flashes for another 60 seconds). The connection between remote
and receiver was successful.
Note: sometimes the connection can take more than 10
seconds!!
It's necessary that a reference movement is now performed. Now
keep the connecting button A pressed. Both motors of the bed are
moving to their Zero Position. When the white LED light on the
motor flashes 2 x, the reference movement was successful.
The adjustable bed is now ready to be used.
After the 60 seconds mentioned above the receiver leaves its
automatic connecting mode; the white LED lights go out and a
manual connecting mode has to be activated.
On the motor, press 2 x the connecting button A until the white LED
lights will light up.
You now enter the manual connecting mode.
Press the remote buttons 1 & 2 (first row) TOGETHER.
The white LED on the motor flashes 2 x and goes out. The
connection between remote and receiver was successful.
Note: sometimes the connection can take more than 10
seconds!!
It's necessary that a reference movement is now performed. Now
keep the connecting button A pressed. Both motors of the bed are
moving to their Zero Position. When the white LED light on the motor
flashes 2 x, the reference movement was successful.
The adjustable bed is now ready to be used.
Werbung
