Remote Control Memory Input / Deletion; Maintenance; Final Notes; Technical Specifications - Automatismos Pujol STC 600N Handbuch

STC
Nombre del Producto modelo
7.5 Receiver shut down
7.5.1 Press the K1 until number 4 is displayed on the screen, the system is now in lock door mode.
7.5.2 Press K3, number 3 will be displayed on the screen and the lock door mode will be on; pressing K4 will display 0 on the
screen and disable the lock door
de bloqueo de puerta.

Remote control memory input / deletion

8.1 Press K2 until a red light appears on the screen, then release K2. Press the channel to be recorded in the
transmitter, release it and press it again, the LED will flash confirming the memory input.
8.2 Follow the above instructions to program additional remote controls. Up to 20 remote controls can be
programmed.
8.3 To delete the memory of the programmed remote controls, press K2 for 8 sec, the LED will flash until all
memory on the controls is deleted; letter C will display on the screen.

Maintenance

The electronic circuitry does not require any kind of maintenance. Examine the door at least twice a year, check its
correct balance and good conditions of all its parts.
Note:
An unbalanced or misaligned door may affect the operator's useful life due to improper loads, and will also void the
product's warranty. Verify the inversion sensibility at least twice a year, and make the necessary adjustments. Ensure
that all the operator's security devices are functioning correctly (security contact strips, stop button and photocells).
Final notes: This manual must be used solely by qualified and trained personnel for the purpose of the system's
installation. The information contained in this manual is not intended for end users. The adjustments contained in this
manual must not be modified by the end user. It is important that the installer brief his clients on the correct use of the
operator, including the manual disengagement procedure. The installer should inform the system's owner about the
need for preventive maintenance, especially for the security system devices.

Technical specifications

Power supply: 220v +-50Hz
Power supply: 220v +-50Hz
Courtesy light.......3 minutes
Operation temperature...... -20º-70º
Relative humidity.......<90%
Maximum torque for door opening and closing.......600N 800N 1000N
Integrated receiver........433.92MHz
Sensitivity............>1 V in a 50m average distance.
System.................Rolling code
Beacon.......220V 25w
programming:
mode.Pulse la tecla K1 hasta que en la pantalla se visualice el número 4, ahora está en modo
42