Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Prepare and paint tail light panels according to the painting instructions.
2. Preparation
2.1
Clean the inner side of the tail light panels and the tail light from spray haze
with fine sanding paper.
2.2
Clean adhesive surface of tail light panels and tail light with a cleanser thoroughly.
Caution: Do not touch cleaned surface again.
3. Assembly TECHART – tail light panels
3.1
The provided black foil has to be pasted in the top range of the rear lights.
3.2
Apply the enclosed PU – glue to the inside of the double-sided tape. (See fig. 1)
3.3
Remove the protection film completely, affix to the panel and press it firmly. See for
an accurate fit. Remove excessive glue with a cleaner. (See fig.2)
3.4
Affix the panel the way that it has a good overall contact. Remove the tape after a
curing time for at least 12 hours.
fig. 1
MONTAGEANLEITUNG
Mounting instructions
Adhesive tape
Lay on PU glue
3/3
Werbung
