Marquardt Just Drive Comfort 4313 Serie Inhaltsempfehlung Für Bedienungsanleitungen Seite 36

Connecting the USB Device
1. Open the rubber protection cap of the USB port.
2. Connect the USB device to the USB port - direct connection or with a suitable USB ca-

Removing the USB device
1. Disconnect the USB device or the connecting cable from the USB port on the Comfort
2. Close the USB port with the rubber cap.
16
NOTE!
No liability is accepted for damage to the mobile phone caused by the connec-
tion to the Comfort control unit.
ble. A so-called OTG USB cable must be used to charge a device. The direction of con-
nection must be observed.
The new connection is displayed on the connected device.
NOTE!
Please observe the instructions for disconnecting the USB connection in the op-
erating manual of the connected device.
control unit.
NOTE!
The Comfort control unit is only protected against water and dirt when the rub-
ber protection is closed.
NOTE!
To prevent damage to the USB port of the control unit, it is recommended that
the USB cable is also securely attached to the handlebars.
Just Drive Comfort control unit for pedelecs and e-scooters