Learn More - HP Neverstop Laser 1000-Serie Referenzhandbuch

Set up a Wi-Fi Direct connection
Use Wi-Fi Direct to connect to a printer wirelessly—without connecting to an existing wireless network. To use
Wi-Fi Direct:
• Make sure the Wi-Fi Direct light
• To check the Wi-Fi Direct name and password, press and hold the Resume button
to print a Configuration Report.
To learn more, visit www.hp.com/go/wifidirectprinting.
Configure the input tray for different paper sizes
NOTE: This section is applicable only to printer models that support Legal and Oficio paper sizes.
If your printer supports Legal and Oficio paper sizes, you must change the orientation of the paper-length guide
when you switch between large and small paper sizes.
For large paper
(A4/Letter or larger)
For small paper
(A5/A6)
Printer operating environment guidelines
Keep printer out
of direct sunlight

Learn more

Product support
www.hp.com/support/Neverstop1000
4
on the printer control panel is on. If it is off, press the Wi-Fi Direct button
To turn the guide:
1. Tilt up the input tray
slightly and pull it off
the printer
NOTE: The guide is shown being turned for loading paper smaller than A4/Letter.
To load larger paper, turn the guide in the opposite direction.
Recommended
temperature range:
17.5° – 25° C
(63.5° – 77° F)
2. Slide off the guide,
turn it around,
.
and slide it back
onto the track.
Recommended
humidity range:
30% – 70%
on the printer for 3 seconds
3. Reinstall the
input tray
Keep printer in Do not exceed
well-ventilated area voltage limits
HP wireless printing
www.hp.com/go/wirelessprinting
.
.