Philips GC6700 Serie Bedienungsanleitung Seite 9

Problem
Dirty water and
impurities come out of
the soleplate.
Water flushes out of the
soleplate.
The Calc-Clean process
does not start.
The ironing board cover
becomes wet, or there
are water droplets on
the floor/garment.
Possible cause
Steam condenses into water
in the hose when you use
steam for the first time or
have not used it for a long
time.
Impurities or chemicals
present in the water have
deposited in the steam vents
and/or soleplate.
Steam condenses into water
in the hose when you use
steam for the first time or have
not used it for a long time.
You have accidentally started
the Calc-Clean process
(see chapter 'Cleaning and
maintenance').
You have not pressed the
CALC-CLEAN button for 2
seconds until the appliance
started beeping.
Steam has condensed on the
ironing board cover after a
long ironing session.
You have an ironing board
that is not designed to cope
with the high steam rate of
the appliance.
Solution
This is normal. Hold the iron away from
the garment and press the steam trigger.
Wait until steam instead of water comes
out of the soleplate.
Perform the Calc-Clean process
regularly (see chapter 'Cleaning and
maintenance').
This is normal. Hold the iron away from
the garment and press the steam trigger.
Wait until steam instead of water comes
out of the soleplate.
Switch off the appliance. Then switch it
back on again. Let the iron heat up until
the 'iron ready' light lights up steadily.
See chapter 'Cleaning and maintenance'.
Replace the ironing board cover if the
foam or felt material has worn out.
You can also add an extra layer of felt
material under the ironing board cover
to prevent condensation on the ironing
board.
Put an extra layer of felt material under
the ironing board cover to prevent
condensation on the ironing board.
English
11