Allocating heating zones
Now supply operation voltage to the Radio Basis 868 MHz
(Types AB 4071 / B 2070 / B 4070), if this has not already
been performed. After that, the LCD Thermostat Radio can
be assigned to the corresponding heating zone for a room,
using the connection unit.
After activating the learning mode of the desired heating
zone at the Basis (see Radio Basis manual) the assignment
of the desired heating zone is performed by pressing the
SET button at the planned place of installation for the LCD
Thermostat radio. A log-on code will be sent to the Basis.
Set button
33
DEU
ENG
DAN
NOR
SWE
FIN
FRA
ITA
NLD
SPA
RUS