Operation; Layout - Schaudt LT 45X Bedienungsanleitung

Operating Instructions Operator and control panel LT 45X
2.5
1.4
1.3
1.2
2
1.1
Fig. 2 Layout of LT 45X control panel
1 Touch sensor
-- --
Main switch, 12 V ON/OFF:
For switching on and off the 12V supply of the
1.1
vehicle
Pump switch:
For switching on and off the 12V supply for
1.2
the water pump
Light power:
For switching on and off the 12V supply for
1.3
the leisure area lighting
AUX supply:
For switching on and off the 12 V AUX supply
1.4
(e.g. for radio and TV)
1.5 Check of leisure area battery voltage
1.6 Check of starter battery voltage
1.7 Check of water tank level
1.8 Check of waste water tank level
6
3

Operation

3.1

Layout

The LT 45X control panel is intended for installation in a cabinet or wall.
2.4 2.3 2.2 2.1 2.6 2.7
1
2 Displays
LED mains indicator (yellow):
The LED lights up when mains voltage is pre-
sent at the input of the vehicle mains supply
2.1
(also refer to the instruction manual for the
relevant EBL ... , Section "Starting up").
Indicator LED (green):
2.2
Display: 12 V vehicle supply ON
Indicator LED (yellow):
2.3
Display: Pump supply ON
Indicator LED (yellow):
2.4
Display: Power for lighting ON
Indicator LED (yellow):
2.5
Display: AUX power ON
8 LEDs (2 red -- 2 yellow -- 4 green):
2.6 2 6 Display of battery voltage in 8 increments and Display of battery voltage in 8 increments and
warning of total discharge.
8 LEDs (blue):
2 7 2.7 Display of water and waste water tank levels Display of water and waste water tank levels
(four increments).
Date: 29.05.2020
1.5
1.7
1.8
1.6
9310330 BA / EN