Jumbo ayce LPL-15A-4 Gebrauchsanweisung Seite 33

CAUTION: In order to avoid a hazard due to inadvertent resetting
●
of the thermal cut-out, this appliance must not be supplied
through an external switching device, such as a timer, or con-
nected to a circuit that is regularly switched on and off by the utility.
If the cord is damaged, it must be replaced by the manufacturer,
●
its service agent or similarly qualified persons in order to avoid a
hazard.
Make sure the voltage is the same as that indicated on the rating
●
plate of the appliance.
Keep the appliance and cable away from sources of heat, sharp
●
objects or anything that may cause damage.
Ensure the appliance is switched off before connecting to the
●
mains power supply.
To disconnect the appliance, switch it "OFF", and then remove
●
the plug from outlet. Do not pull the cord to disconnect the plug.
Switch off the power supply and disconnect from mains supply
●
when not in use, before cleaning or other maintenance.
Do not operate in areas where gasoline, paint or other flam-
●
mable liquids are used or stored.
The heater is for Indoor use only.
●
To prevent a possible fire, do not block air intakes or exhaust in
●
any manner.
Don't touch the hot surfaces.
●
Do not use pesticide or other flammable spray around the prod-
●
uct. Because it will damage the device and cause fire.
Do not insert or allow foreign objects to enter any ventilation or
●
exhaust opening, as this may cause an electric shock, fire or
damage to the appliance.
Always ensure that hands are dry before operating or adjusting
●
any switch on the product or touching the plug and socket-outlet.
Do not leave this appliance unattended when it's in use.
●
The most common cause of overheating is deposits of dust or
●
fluff in the appliance. Ensure these deposits are removed regu-
larly by disconnect the appliance and vacuum cleaning air vents
and grilles.
Do not place the heater on carpet; don't place the cable under
●
carpets. Arrange cord away from traffic areas so that it will not
be tripped over.
The supply voltage and utility frequency, specified on the
●
machine, need to match those of the socket that is used. The
socket used needs to be earthed and the electrical installation
needs to be secured with a ground-fault circuit interrupter (max.
30 mAmp).
Fully extend the cord before plugging in the heater. Make sure it
●
does not come into contact with any part of the heater and pre-
vent it from heating up any other way. Do not run the cord
underneath carpeting; do not cover it with mats, carpet strips or
similar and make sure it is not placed in any passageways. Make
sure the cord cannot be stepped on and that no furniture is
placed on top of it. Do not lead the cord around sharp corners
and do not roll it up too tightly after use!
64 | 65
GB